Search This Blog

Friday, December 18, 2015

Receiver Binding Options

FrSky X8R

After everything is setup execute these steps
1) Press [bind] in the Taranis menu
2) press and hold down the F/S button on the X8R (skip for Mode1)
3) power-on the X8R by plugging in a single servo cable from the powered model, e.g. the S.BUS cable
4) wait for the Taranis to beep. (~1second) and your RX is blinking red. This confirms a successful bind.
5) power off the rx
6) remove the jumpers, they are only needed for binding

FrSky X4R / X4RSB

No comments:

Post a Comment